PINBALL MOLEX CONNECTORS PROFESSIONAL

'Randy is always very professional and extremely knowledgeable about the work that needs to be done.

'Randy just left here and after over 20 years I now have a jukebox that works.' -Jeff, Aurora, CO.

He was very professional and knowledgeable and I feel he has the ability to troubleshoot anything pinball or anything electronic for that matter.' -Craig H., Broomfield, CO

'Randy was there an hour and found the problem and also a couple other potential issues.

Randy has worked on my three Williams machines (Taxi, T2, and Funhouse) and based on his previous work, I am confident he could solve any future issue.' -Greg M., Louisville, CO He has always arrived promptly with all the tools and parts needed to efficiently complete the jobs.

'Randy is a true professional with amazing knowledge of electrical wiring, programming, boards and mechanical workings.

Posted in Pinball, Repairs | Tagged Bally, connectors, EM, lights | Leave a reply Since the lights on this machine hadn’t worked in years, there were a few tune-up related items that needed to be done, such has replacing burned out bulbs and cleaning some relay and stepper contacts to get all of the lights working again. Had it been a connector for removing the backbox or playfield, I probably would have installed a single pin Molex connector or something similar for the bad wire. Most EM pinball machines don’t even have this connector, so I had no problem just splicing the bad wire together and bypassing the connector. This is a little used connector which would only be used if one were removing the control board from the pinball machine, which is pretty rare. In this case, the connector was between the control board plywood with all of the relays mounted on it and the fuse block on the right side of the cabinet near the tilt mechanism. Unlike the newer machines where new connectors can be installed, the old ones require a work-around. He is the best out there that can be found for pinball and juke box repairs.' -Larry, Sidney, NE.Burnt lighting connector from Bally EM pinball machine.

Posted in Pinball, Repairs | Tagged Bally, connectors, EM, lights | Leave a reply World Cup Soccer Pinball Machine, Williams, 1994 This tool is a must for anyone working with the popular arcade.

PINBALL MOLEX CONNECTORS SERIES

Had it been a connector for removing the backbox or playfield, I probably would have installed a single pin Molex connector or something similar for the bad wire. Molex Extractor Tool is for the removal of 2.13mm (.084) Diameter Series pin and socket male and female crimp terminals from both plugs and receptacles connectors. Burnt lighting connector from Bally EM pinball machine.

Pinball molex connectors